Switching On The Display; How To Navigate Xp10 At The Surface - SubGear XP10 Mode D'emploi

2.4 Switching on the display

S
L
O
W
Time of day display
F

2.5 How to navigate XP10 at the surface

Starting from the time of day display you can enter into different menus.
Off
O mix /
2
ppO
2
->20
• Enter with into the
function or sub menu.
• With you can switch
to the time of day display.
• After 3 minutes without
operation XP10 returns to
the time of day display.
• automatically, on submerging in water* or when adaptation to atmospheric
pressure is necessary;
• manually, by pushing
light up for 5 seconds.
Afterwards the display shows the time of the day, the O
temperature.
F
This display is called time of day display. Most navigation descrip-
tions start from this display. At the surface XP10 returns automati-
cally to this display.
If there is a remaining saturation from the last dive or from a change of altitude,
XP10 also displays the "do not fly" time, the "do not fly" icon, the current
altitude range and the prohibited altitude range (->26).
When XP10 is in state of rest no information is displayed but the
atmospheric pressure is continuously monitored. If a change in
altitude range is detected, XP10 switches on for 3 minutes automati-
cally ->27.
* Only if the option "Water contacts on" ("set 1", ->33) is chosen. See warning ->10.
Time of day display
Set 2
max
->34
• Alarm clock
• UTC time zone
• Time of day
• Date
• 24h / AM PM
• LCD contrast
• IrDA speed
• Sound on / off
• Electronic ID
or . If switched on with
• (Desat. time CNS O
• Date
• Battery condition
Set 1
->32
/
• ppO
->34
• Reset to air
->34
• Unit system
->34
• Unit system
->35
• Attention beep
->35
on /off
->35
• Water contacts
->35
on /off
->35
• Reset
->36
desaturation
Operation
all segments
mix and the
2
% ) ->14
2
->14
->14
Dive Logbook
planner
->29 ->30
/
max ->32
2
->32
->32
->34
->33
->33
->33
13