IV Dive planner
PLn: XP10 has a dive planner which allows the planning of no-stop dives.
Basis of the planning:
1 Planning a no-stop dive
To select the dive planner XP10 must be in user mode (time of day display). Push
the symbol for the dive planner PLn appears.
Select dive planner
or
until PLn
if
Enter the
dive planner
if rep. dive
DEPTH
DEPTH
DIVE TIME
NO STOP
No-stop time
Set desired depth
(
and
)
Depths deeper than the MOD for the selected gas (O
On page 27 you will find further information and safety considerations regarding the no-dive
warning.
2 Leaving the dive planner
By pushing once or twice
without operation.
• selected fraction of oxygen and MOD
• water temperature of the most recent dive
• altitude range (if any)
• status of saturation at the time the dive planner is selected
• assuming a normal workload of the diver and observance of
the prescribed ascent rates
Dive planner icon
CNS O
%
2
Input of the surface
interval by pushing
/
Confirm the displayed interval with
With
and
no-stop time.
you can exit the dive planner. This also occurs after three minutes
No-dive warning
(Do Not Dive)
Duration of the
warning
The input window for the time interval is
displayed if there was a remaining desaturation
(DESAT) before the dive planner has been
selected. This surface interval between now
and the beginning of the dive can be changed
with
and
XP10 displays the CNS O
altitude section to which you may not rise at
the end of the selected surface interval.
If the no-dive warning and its duration
has been displayed, XP10 proposes this
time – rounded up to the next 15 minutes –
as surface interval. If the proposed interval is
shortened, the no-dive warning appears.
(if applicable).
set the depth for which you want to know the
mix) are not displayed.
2
Dive planner
or
until
The
no-dive
warning
and
its
duration are displayed
if XP10 detects an
increased risk due to
the accumulation of
microbubbles.
Enter the dive planner
with
.
in steps of 15 minutes.
% value and the
2
29