Table des Matières
Publicité
•
Unfold the hopper bag and lay the bag out with the
wind screen on top.
•
Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag.
fIGURE 8
•
Insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag.
fIGURE 9
STITCHED SLEEVE
7
•
Slide the upper hopper tubes back underneath the
mesh wind screen and attach the ends of the upper
hopper tubes to the outside of the lower hopper
tubes using two 3/8" x 3/4" hex bolts (24) and 3/8"
nylock nuts (29), inserting the bolt from the inside of
the bag. Tighten and then loosen 1/4 to 1/2 turn.
fIGURE 10
•
Insert the ends of the hopper support rods (15) into
the holes in the upper and lower rear hopper tubes by
flexing the rods just enough to fit into the holes.
IMPoRTANT: Do not over-flex the rods. Over-flexing will
cause the steel rods to loose supporting tension.
15
fIGURE 11
24
29
Publicité
Table des Matières
