Table des Matières
Publicité
TooLS REQUIRED foR ASSEMBLY
(2)
7/16" Open End or Box End Wrenches
(2)
1/2" Open End or Box End Wrenches
(2)
9/16" Open End or Box End Wrenches
Note: Right hand (R.H.) and left hand (L.H.) are
determined from the operator's position while seated on
the tractor.
•
Assemble the R.H. and L.H. hitch tubes to the
sweeper housing using four 5/16" x 1-3/4" hex bolts
(19) and 5/16" nylock nuts (28). Do not tighten yet.
fIGURE 1
•
Install two 5/16" x 3" hex bolts (17) and 5/16" nylock
nuts (28) in the ends of the hitch tubes. Do not
tighten yet.
fIGURE 2
ASSEMBLY
19
28
28
17
•
Measure the height of your tractor's drawbar. The
height will determine the arrangement of the sweeper
hitch brackets.
•
Assemble the hitch brackets to the hitch tubes. using
two 5/16" x 2-1/4" hex bolts (18) and 5/16" nylock
nuts (28). If your tractor drawbar has 10" or more
ground clearance, place the bent hitch bracket on top.
If it has less than 10" clearance, place the straight
hitch bracket on top. Do not tighten yet.
•
Tighten all loose bolts and nuts as follows:
Tighten the bolts and nuts assembled in figure 1.
Tighten the bolts and nuts assembled in figure 2.
•
Assemble the hitch pin (36), two 3/4" spacers (32)
and the large hairpin cotter (33) to the hitch brackets.
10" - 13"
(25 - 33 cm)
18
28
fIGURE 3
5
8" - 10"
(20 - 25 cm)
36
32
33
28
18
36
32
33
Publicité
Table des Matières
