Fusion Apollo RA770 Mode D'emploi page 5

NMEA 2000 System Wiring Diagram
Stereo
Supported chartplotter MFD or compatible FUSION NMEA 2000 remote control
In-line switch
NMEA 2000 power cable
NMEA 2000 drop cable from the stereo, up to 6 m (20 ft.)
NMEA 2000 drop cable from the chartplotter MFD or compatible FUSION NMEA
2000 remote control
9 to 16 Vdc power supply
NMEA 2000 terminator or backbone cable
NMEA 2000 T-connector
NMEA 2000 terminator or backbone cable
Configuring an Optional Wired Remote
NOTICE
The stereo is configured by default to work with a NMEA 2000 network, and
the NRX POWER option should be enabled only when an optional remote is
connected directly to the stereo. Enabling this option when the stereo is
connected to a NMEA 2000 network may damage other devices on the NMEA
2000 network.
If you connect an optional wired NRX remote directly to the stereo, and not
through a NMEA 2000 network , additional configuration is needed.
1
Select > > NMEA.
2
Select an option:
• If you connected both your stereo and your optional wired remote to a
NMEA 2000 network, make sure the NRX POWER option is not
selected. This enables the optional remote to receive power from the
NMEA 2000 network.
• If you connected the optional wired remote directly to the stereo
through the NMEA 2000 connector, select the NRX POWER option.
This enables the stereo to supply power to the optional remote.
FUSION PartyBus Networking
The FUSION PartyBus networking feature allows you to connect multiple
compatible stereos and zone stereos together on a network, using a
combination of wired or wireless connections.
A FUSION PartyBus stereo, such as an Apollo RA770 stereo, can stream
sources to other FUSION PartyBus devices connected to the network.
Connected FUSION PartyBus devices can also control media playback on the
FUSION PartyBus stereo. A FUSION PartyBus zone stereo, such as an Apollo
SRX400 zone stereo can stream from a FUSION PartyBus stereo, but cannot
stream sources to other FUSION PartyBus devices on the network.
You can connect up to eight FUSION PartyBus devices on a network.
Installation Instructions
In the image above, one Apollo RA770 stereo
and to two Apollo SRX400 zone stereos
stereo zone stereos can stream sources from the FUSION PartyBus stereo.
A FUSION PartyBus zone stereo is not the same thing as a speaker zone. It is
an independent stereo that can either play media from connected sources or
stream from a FUSION PartyBus stereo on the network. You can connect a
FUSION PartyBus zone stereo, such as an Apollo SRX400 zone stereo, to a
single speaker zone . You can connect a FUSION PartyBus stereo, such as
an Apollo RA770 stereo, to multiple speaker zones
with that stereo. FUSION PartyBus devices cannot control the speaker volume
of another stereo. You can adjust the volume of speakers or speaker zones
connected directly to the stereo only.
Wired Networking Considerations
When you are planning your network installation, observe the following
considerations for all wired connections.
• Wired connections are more reliable than wireless connections. When
planning your network, you should use network cables to connect FUSION
PartyBus devices to the network when possible.
• You must connect devices using standard Cat5e or Cat6 network cables
with RJ45 connectors.
• You can use one network cable to directly connect two compatible devices.
• You may need to use wired network switches and wired or wireless
network routers when you connect more than two compatible stereos to a
network.
• If you install a router on the network, it should be configured to be the
DHCP server by default. See your router instructions for more information.
• If you do not install a router on the network, you must configure one
FUSION PartyBus device to be the DHCP server.
Wired Network Example for Direct Connections
You must configure one FUSION PartyBus device as a DCHP server when
connecting two devices together directly.
FUSION PartyBus stereo
FUSION PartyBus zone stereo
Wired Network Example with a Switch or Router
You must use wired network switches, a wired network router, or both to
connect more than two FUSION PartyBus devices.
connects to a wireless router
. The two FUSION PartyBus
to cover a larger area
5