Central Lubricating System; Changing The Jaws; Daily Inspection - Rothenberger COLLINS RHINO 4 Instructions D'utilisation

6.1

Central lubricating system

Proper lubrication of the spindle bearings and brake band
is essential for trouble-free operation and long life for the
machine. The central lubricating system makes this a very
easy procedure.
Check the reservoir and refill if necessary with SAE 30
weight lubricating oil into inlet.
Once a day, before starting the machine for the first time,
lift and release the lubricator plunger six times. During
normal operation, lift and release the plunger four times
every two hours of operation.
Replace filter element once a year on the central lubricator
pump.
6.2

Changing the jaws

Keep clean with wire bush to avoid slippage. To replace jaws:
Unplug machine
Remove spindle cover
Remove jaw retaining rings and slide jaws off shaft
If machine has been used for only right hand threading, reverse jaws and remount on jaw shafts
so that the unused side faces spindle opening.
Inspect jaw shaft keys for wear.
Install replacement jaws so that single row jaws (1) are opposite each other and doubles (2)
are opposite each other. Also alternate single and double jaws between front (3) and rear
chucks (4).
6.3

Daily inspection

Attention! Before starting the lubrication-works the power plug has to be
taken out of the power source.
Check the mains plug, mains cable and extension cable to ensure they are undamaged.
Correctly filled oil trough
Adjust the oil screw if necessary
Clean the oil tank if there are impurities in it.
Inspect the thread- jaws, pipe cutter and internal deburrer for any wear and replace parts if
there is wear.
Clean the clamping jaws with a wire brush if they are dirty.
34
1
2
3
4
ENGLISH
Plunger
Inlet
Filter element