Getting Started; Unpacking; Items Supplied - Evolution R255 SMS Notice Originale

www.evolutionpowertools.com
11. Always use safety glasses. Also use face
or dust mask if cutting operation is dusty.
Everyday eyeglasses only have impact resistant
lenses, they are not safety glasses.
12. Secure work. Use clamps or a vise to hold
work when practical. It's safer than using your
hand and it frees both hands to operate tool.
13. Don't overreach. Keep proper footing and
balance at all times.
14. Maintain tools with care. Keep tools
sharp and clean for best and safest
performance. Follow instructions for
lubricating and
changing accessories.
15. Disconnect tools before servicing; when
changing accessories, such as blades, bits,
cutters, and the like.
16. Reduce the risk of unintentional stating.
Make sure switch is in off position before
plugging in.
17. Use recommended accessories. Consult
the owner's manual for recommended
accessories. The use of improper accessories
may cause risk of injury to persons.
18. Never stand on the tool serious injury
could occur if the tool is tipped or if the cutting
tool is unintentionally contacted.
19. Check damaged parts. Before further
use of the tool, a guard or other part that
is damaged should be carefully checked to
determine that it will operate properly and
perform its intended function - check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A guard or other part that is damaged should
be properly repaired or replaced.
20. Direction of feed. Feed work into a blade
or cutter against the direction of rotation of
the blade or cutter only.
21. Never leave tool running unattended.
Turn power off. Don't leave the tool until it
comes to a complete stop.

GETTING STARTED -

(4.1)

UNPACKING

Caution: This packaging contains sharp
objects. Take care when unpacking. This
machine could require two persons to lift,
assemble and move this machine. Remove
the machine, together with the accessories
supplied from the packaging.
Check carefully to ensure that the machine
is in good condition and account for all the
accessories listed in this manual. Also make
sure that all the accessories are complete.
If any parts are found to be missing, the machine
and its accessories should be returned together
in their original packaging to the retailer.
Do not throw the packaging away; keep it safe
throughout the warranty period. Dispose of
the packaging in an environmentally
responsible manner. Recycle if possible. Do not
let children play with empty plastic bags due to
the risk of suffocation.

ITEMS SUPPLIED

(4.2)
Product Code
Rotary Table And Neck
Cutting Head
Carriage Slides
Miter Locking Knob
Mains Cable Guide/Clamp
Machine Table Extensions
Double Ended Hex Key (M6 & M5)
Socket Headed Screw X1
Socket Headed Screws x4
Cable Clamp Component
Laser Lens Cap
Double Ended Cable Clip
Dust Collection Bag
3pc Hold Down Clamp
10 inch 24 Tooth Blade
11
EN
FR
(CA)
052-0004
ES
(LA)