FAZUA evation 1.0 Notice Originale page 7

EN
Operation
Requirements
For running the eBike drive system, following requirements must be followed:
• The Battery Pack is sufficiently charged, inserted and turned on (see
Battery Pack Instructions).
• Drivepack (1) is mounted in the eBike.
• The speed sensor is properly connected to the Bottom Bracket and
spoke magnet justly placed (see Bottom Bracket Instructions).
Switching eBike System On/Off
The system can be operated by a FAZUA approved Remote. Once the
Drivepack (1) is mounted in the eBike, the system can be switched on by
simply pressing any of the Remote buttons (see Remote Instructions).
The system output power depends on the support level settings on the Remote.
When you stop pedaling, or a speed of 25 km/h is reached, the support from
the drive system is gently switched off. The system switches on again when
you start pedaling and the speed is below 25 km/h.
There are different ways to switch off the system:
Press and hold the middle button of the Remote for 2 s (see Remote
•
Instructions).
• Unmount the Drivepack (1) from the bike.
• Switch off the Battery Pack (see the Battery Pack Instructions).
• Let the eBike enter into inactivity.
10
Setting the Support Level
You can set on the Remote to what extent should the eBike system support
you when pedaling. The support level can be set at any time, even while
riding. To switch the support level, you must press the up/down buttons on the
Remote (see Remote Instructions).
The following support levels are available:
• No Support (white): The motor support is switched off. The eBike can
be driven as a normal bicycle.
• Breeze (green): Low but efficient support to maximize the eBike range.
• River (blue): Solid support suitable for most of scenarios.
• Rocket (pink): Maximum support for the most demanding tours.
Support Level Color
No Support White
Breeze Green
River Blue
Rocket Pink
Switching the Walk-assistance mode on/off
The Walk-assistance function helps to push the eBike. The speed of the eBike
in Walk-assistance mode may vary depending on the set gear, with maximum
speed of 6 km/h. The user can reduce the speed of the eBike to his own by
holding it firmly while walking.
Warning! The Walk-assistance mode is intended to be used only
while pushing the eBike. A misuse of the Walk-assistance mode
assumes risk of injury.
To activate the Walk-assistance mode, set your system to "No Support" mode
on the Remote (See Remote Instructions). Then, press and hold the "Down"
button on the Remote. After 2 s the Walk-assistance mode switches on.
Warning! Make sure your hands are firmly holding the handlebar
of your eBike when using this function, otherwise you may
momentarily lose control over the eBike.
Max. Support Factor Max. Power
0% 0 W
75% 125 W
150% 250 W
240% 400 W
11
EN