FAZUA evation 1.0 Notice Originale page 6

EN
Assembly
Inserting/removing the Battery Pack
To insert/remove the Battery Pack in/from the eBike, follow the Battery Pack
Instructions.
Mounting the Drivepack in the eBike
After inserting the Battery Pack in the Drivepack (1) (see the Battery Pack
Instructions), lay the interface to Bottom Bracket (3) over the open interface
on your Bottom Bracket (Action A, Step 1). right underneath your eBike
downtube.
Now bring the upper part of the Drivepack (1) inside the downtube until the
fastening hook (8) hooks in (Action A, Step 2). Make sure the Drivepack (1) is
tightly anchored within the downtube and does not come out.
Dismounting the Drivepack from the eBike
Important! Make sure that you are holding your Drivepack (1)
when dismounting it, otherwise the Drivepack (1) may fall freely
from the frame.
Hold the mounted Drivepack (1) with one hand and press the release
button (6) with the other hand (Action B, Step 1). You can now remove the
Drivepack (1) easily (Action B, Step 2).
Note! Sometimes pushing up the Drivepack (1) against the frame
before pressing the release button (6) may result in a smoother
dismounting.
8
Locking/unlocking the drivepack within
your eBike
Once a Drivepack (1) is mounted in the eBike, it can be locked in so that the
Drivepack (1) cannot be removed. To lock a mounted Drivepack (1), insert
the key (10) into the lock cylinder (9) and turn it counter-clockwise (Action
C).
To unlock the Drivepack (1) from the eBike, insert the key (10) into the cylinder
(9) and turn it clockwise (Action D).
Charging the Battery Pack in your bike
Warning! Read carefully and respect the battery instructions.
Warning! Pay attention to your battery before each use and before
charging. Make sure terminals and surfaces are clean.
Warning! Before using or charging your Battery Pack, always look
for signs of damage like cracks or burns. Never use or charge a
damaged Battery. Please contact your FAZUA Service Partner or
visit the FAZUA Service Platform (www.fazua.com/service).
The Drivepack (1) can be mounted in the eBike, leaving the charging port of
the Battery Pack accessible to connect the charger. For that, dismount the
Drivepack (1) from the eBike (Action B). Push up the pressing chock (7) at
the lock (5) and the fastening hook (8) will come out (Action E, Step 1). Now
mount the Drivepack (1) back into the bike without pushing the upper part
all the way in (Action E, Step 2). This way, the fastening hook (8) fastens the
Drivepack (1) without being completely inserted.
EN
9