afriso CosiTherm BM Notice Technique page 51

5.4 Mounting modules on a DIN rail
 Verify that all modules (base module and controller modules) are plugged
together and firmly locked.
 Verify that all cables are connected.
Mounting
B
2. Repeat this procedure for all other
cables.
B
3. It is possible to open the cable
clamps. To do so, pull the two
tabs (2) outwards and remove the
cable clamp.
1. Fit the modules (base module and
controller modules) into the DIN
rail with the upper hooks.
2. Push the lower end of the mod-
ules (base module and controller
modules) towards the DIN rail
until they snap in with a click.
EN
19
BM