Hyundai LM3301E Mode D'emploi D'origine page 26

Blade Maintenance (Image G)
Before the blade maintenance, the device
should be disconnected from the mains and
cleaned. Remove the grass basket. Wear
the appropriate gloves. A wooden block is
needed to pinch the blade (not included).
G1: Place the device on the side. Clamp
the wooden block so that the blade can not
rotate. Use the wrench (not included) to
loosen the screw. Remove the screw, shim
and blade.
G2: Replace the blade with a new one.
Make sure that the blade is correctly
positioned on the support. Insert the shim
and tighten the screw slightly.
G3: Re-clamp the block so that the blade
can not rotate. Tighten the screw securely
with the wrench. Always use a torque
wrench (not included).
Storage (Image H)
The lawn mower needs to be stored dry and
clean in a closed room with good ventilation
out of the reach of children.
H1: Disconnect the device from the mains
and allow it to cool down. Remove the
grass basket.
H2: Loosen the wing nut and turn the
handlebar down.
H3: Press the buttons and pull out the two
rods of the lower handlebar.
H4: Place the grass basket on top of the
mower. This way the device can be stored
permanently.
CONFORMITY
We hereby declare on our sole and
exclusive responsibility that the models
LM3301E, LM3301ES
manufactured in series by our facility,
comply with the following harmonized EU
guidelines and EU standards with regard to
safety and product-specific standards.
2006/42/EC, 2014/30/EC,
2000/14/EC Annex VI, 2011/65/EU
Applied Standards:
EN 60335-1:2012 +A11:2014, EN 60335-2-
77:2010, EN 62233:2008, EN 55014-2:2015,
EN 55014-1:2006/+A1:2009/+A2:2011,
EN 61000-3-2:2014, EN 61000-3-11:2000,
ISO11094:1991, EN ISO3744:1995, Annex III
of 2000/14/EC as amended by 2005/88/EC,
IEC 62321-1: 2013, IEC 62321-2: 2013
Guaranteed sound power level LwA,
96 dB(A)
Vibration <4.5 m/s
Notified body:
Intertek Testing&Certification
Avenue, Knowlhill, Milton Keynes, MK5 8NL,
No. 0359
Documents kept at the domicile of the
manufacturer: HPP AG, Churerstrasse 135,
CH-8808 Pfäffikon SZ.
EU importer: HPP Pro GmbH, Rheinblick 7,
DE-79725 Laufenburg.
Pfäffikon SZ, 31.10.2018
------------------------
Dr. E. Ilinich (Managing Director)
EN 26
2
Ltd, Davy