Tyres Pressures; Maintenance; Replacing Discs (Workshop Work); Mounting Tyres (Workshop Work) - Alpego PUMA PF Série Manuel D'utilisation Et Entretien

OWNER'S MANUAL OF THE MULCH CULTIVATOR PF-PD

7.9.1. TYRES PRESSURES

•
The required tyre pressure is dependent on
tyre size.
-
tyre load rating.
-
speed of travel.
-
•
The operational performance of the tyres is reduced
by overloading.
-
if tyre pressure is too low.
-
if tyre pressure is too high.
-
•
The difference in pressure between the tyres on one axle must be no greater than 0.1 bar.
•
Tyre pressure can be raised by up to 1 bar after a fast run or in warm weather. Tyre pressure should on no
account be reduced as it is then too low when the tyres cool down.
•
Check tyre pressures regularly when the tyres are cold, i.e.before starting a run.

8.1. REPLACING DISCS (WORKSHOP WORK)

Danger of injury or death from unintentional lowering of the raised implements.
Mount the locking device against unintentional lowering of the coulter
Minimum disc diameter: 460 mm.
The discs are replaced with the machine folded in, the machine lifted, headland setting
the discs raised the machine secured against unintentional lowering

8.1. MOUNTING TYRES (WORKSHOP WORK)

•
Remove any outbreaks of corrosion from the wheel rim seating surfaces before fitting a new/another tyre.
Corrosion can cause damage to the wheel rims when the vehicle is in operation.
•
When fitting new tyres, always use new valves for tubeless tyres or new inner tubes.
•
Always fit the valves with valve caps which have a gasket insert.
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa

8. MAINTENANCE

Old Cod.Q00A00142
New Cod. MANT2010/00493 R.1
MAINTENANCE
- 31