Pulled Machine - Alpego PUMA PF Série Manuel D'utilisation Et Entretien

OWNER'S MANUAL OF THE MULCH CULTIVATOR PF-PD
The ballast to add is calculated with the formula:
To determine the actual tractor front axle load, the following formula has to be used:
The actual total weight of the tractor/implement combination is calculated as:
The rear axle load is calculated as:

6.2.3. PULLED MACHINE

A2 A1
A
FigurE 6-2
Distance between the centre of gravity of the front machine mounting or the front weight and the
A
lower link connection (a1 + a2) (m)
B Tractor wheel base (m)
C Distance between the centre of the rear axle and the centre of the lower link connection (m)
A1 Distance from the centre of the front axle to the centre of the lower link connection (m)
Distance between the centre of the lower link connection point and the centre of gravity of the front
A2
machine mount or front weight (centre of gravity distance) (m)
Gv
Front weight (if available) (kg)
Gv Maximum drawbar load (kg)
Te Empty tractor weight (kg)
Tv Front axle load of the empty tractor (kg)
Th Rear axle load of the empty tractor (kg)
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
B C
Gh
Old Cod.Q00A00142
New Cod. MANT2010/00493 R.1
1
1
1
1
1
3
3
2
2
2
COMMISSIONING
- 23