Publicité
Les langues disponibles
Les langues disponibles
ge nera l inf orm a t i o n
4
g e n e r a l
n o t e :
electrical connection
G B
When the appliance does not have a
connecting cable with a plug, then it may
be connected to the mains only by an
approved installer.
The power rating and required mains
voltage are shown on the data plate.
Connection should take place according to
national and local regulations. These
include, amongst others, a requirement that
the appliance should always be earthed.
Use good quality cable for connecting, e.g.
H05RRF 1.5 mm
, with 3 or 5 cores,
2
depending upon the regulations.
With following colour code:
brown =
phase L
blue =
phase N
green/yellow =
earth (
)
black =
phase L or N
Depending upon the wiring diagram, you
can use the black cores for neutral or a
p h a s e .
The cable must have a plug suitable for a
nominal load of at least 15 A.
There is a label showing the wiring
diagrams on the underside of the appliance.
If you want to make a fixed connection,
ensure that a multi-pole switch with a
distance between contacts of 3 mm is
installed in the supply cable.
bui ldi ng i n di me ns ion s an d ve ntil ation
I E
Take care:
- This hob is a category "Y" appliance. This
means that there can be a tall cabinet or
wall behind it, or next to it.
There may be no appliance or wall higher
than the appliance at the other side of
the appliance.
- The appliance generates heat. There
must be a distance of at least 30 mm
between the appliance and a cabinet next
to it.
The distance between the appliance and
an extractor hood must be at least 650
m m .
Building-in dimensions with several
e l e m e n t s
Width (B)
D e p t h
1 element
2 6 5
4 9 0
2 elements
5 5 8
4 9 0
3 elements
8 5 1
4 9 0
4 elements
1 1 4 4
4 9 0
5 elements
1 4 3 7
4 9 0
Extraction unit
Building in between 2 elements:
- increase dimension B by 90 mm
building in on the outer side of a
c o m b i n a t i o n :
- increase dimension B by 98 mm.
5
Publicité
