Intended Use; Preparation For Use - 3M G22 Mode D'emploi

GZX
3M™ Industrial Safety Helmets

INTENDED USE

This product meets the requirements of EN397:2012, Industrial Safety Helmets. This product is designed to protect
the wearer against objects likely to strike the head. For specific performance requirements see Technical
Specification. See all instructions for use and save for continuing reference.
^ Particular attention should be given to warning statements where indicated.
^ WARNING
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
Proper selection, training, use and appropriate maintenance are essential in order for the product to
help protect the wearer from impact hazards.
Failure to follow all instructions on the use of these personal protection products and/or failure to
properly wear the complete product during all periods of exposure may adversely affect the wearer's
health, lead to severe or life threatening illness or permanent disability.
For suitability and proper use follow local regulations, refer to all information supplied or contact a
safety professional or 3M on 0870 60 800 60 (UK) or 1800 320 500 (Ireland).
harness, and even though such damage may not be readily apparent, any helmet subjected to severe impact
should be replaced.
of the helmet, other than as recommended by the helmet manufacturer. Helmets should not be adapted for the
purpose of fitting attachments in any way not recommended by the helmet manufacturer.
the helmet manufacturer.
durability of the helmet and should therefore be avoided.
application such as horse riding or bike riding.

PREPARATION FOR USE

Inspection
Ensure that the head harness is always attached to the helmet at the appropriate points and securely fitted to the
head before it is worn.If required, replace the complete head harness assembly only.Before each use the helmet
should be inspected for cracks, cuts or other damage and should be rejected and disposed of if these are
Fitting
tensioned in their attachments. The 3M™ H700 and G3000 safety helmets are also approved with the suspension
rotated through 180°.
Helmet adjustment (See figure 2)
the standard suspension, press the studs into the holes. The height of the head harness can be set at a choice of 3
IN USE
It is recommended that you replace your helmet 2-5 years from date of manufacture dependant on the environment
14