Air Supply; Lubrication - Napa 6-1124 Mode D'emploi

AIR SUPPLY

Tools of this class operate
on a wide range of air
pressures. We recommend
that air pressure measures 90
PSI at the air inlet while in
use. Low pressure (less than
90 psig/6.2 bar) reduces the
speed and performance of all
air tools. High pressure (over
115 psig/6.2 bar) exceeds the
rated capacity of the tool,
which will shorten tool life
through faster wear and
could cause injury.

LUBRICATION

Lubricate the air motor daily
with NAPA air tool oil. If no
air line oiler is used, run
1/2 oz. of oil through the
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE ThIS mAN U AL fOR fUTURE REfERENCE.
6-1124
Always use clean, dry air.
Dust, corrosive fumes, and/
or water in the air line will
cause damage to the tool.
Drain the air tank daily.
Clean the air inlet filter
screen at least once per
week.
The air inlet used for
connecting the air supply has
standard 1/4" NPT American
Thread. Line pressure should
be increased to compensate
for unusually long air hoses
tool. The oil can be squirted
into the tool air inlet or into
the hose at the nearest
con n ec t ion to the air supply,
3
(over 25 feet). Minimum
hose diameter should be
3/8" I.D. Fittings should
have the same inside
dimensions and should be
tightly secured.
then run the tool. Overfilling
will cause a re d uc t ion in the
power of the tool.
rev. 12/20/10