Air Supply; Lubrication - Napa CARLYLE TOOLS 6-1137 Guide D'utilisation

Clé à chocs très robuste, prise de 1 po et mandrin de 9 po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

AIR SUPPLY

Tools operate on a wide range of
air pres sures. It is recommended
that air pressure mea sures 90 PSI
at the tool with the trigger fully
depressed and no load applied to
the tool. Low pressure (under 90
psig; 6.2 bar) re duc es the speed
of all air tools. Low air pressure not
only wastes time, but also costs
money. Higher pres sure (over 90
psig; 6.2 bar) raises performance
beyond the rated capacity of the
tool, which will short en tool life
and could cause injury. Always
use clean, dry air. Dust, corrosive
fumes and/or water in the air line

LUBRICATION

Lubricate
the
daily with NAPA air tool oil.
If no air line oiler is used, run
1/2 oz. of oil through the tool. The
oil can be squirted into the tool air
inlet or into the hose at the nearest
connection to the air supply, then
run the tool. A rust inhibitive
oil is acceptable for air tools.
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
6-1137
will cause damage to the tool.
Drain water from air lines and
compressor prior to running tool.
Clean the air inlet filter screen
weekly. The rec om mend ed hook­
up pro ce dure can be viewed in
the above figure.
Always use clean, dry air. Dust,
corrosive fumes, and/or water in
the air line will cause damage to
the tool. Drain the air tank daily.
Clean the air inlet filter screen at
least once per week.
The air inlet used for connect­
ing the air supply has standard
air
motor
WARNING: After an air tool has
been lubricated, oil will discharge
through the exhaust port during
the first few seconds of operation.
The exhaust port must be covered
with a towel before applying air
pressure to prevent serious injury.
3
1/2" NPT American Thread. Line
pressure should be increased to
compensate for unusually long
air hoses (over 25 feet). Minimum
hose diameter should be 1/2" I.D.
Fittings should have the same
inside dimensions and should be
tightly secured.
Ensure an accessible emergency
shut off valve has been installed
in the air supply line and make
others aware of its location.
Rev. 05/14/19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Carlyne tools 6-768Carlyle tools 6-767

Table des Matières