Ultraflex UC 128-TS Manuel D'installation Et D'entretien page 13

ULTRAFLEX
9 Fit the set screw (10) on the adjustment collar
(11) and screw it to the right side of the tilt tube
until it comes into contact with the tilt tube stop
nut, even in case of port applications.
1 0
l
l
11
11 Insert the right and left bull horns (12) by
connecting the rod and the tilt tube rod as shown
in the picture without tightening them.
1 2
l
13 Once the correct spacers have been chosen,
remove the bull horns.
14 Insert the plastic and stainless steel spacers
and the two stainless washer on the tilt tube rod.
NOTICE
Both the stainless steel spacers must be positioned
towards the tilt tube on the opposite side of the
bull horns to avoid their wear during engine lifting
and lowering.
10 With reference to the' "Application Guide"
choose the spacers for the tilt tube rod.
LARGE
NOTICE
In this phase ensure that the cylinder body is
centered on the rod and that the engine is
perpendicular to the transom.
The number and position of the spacers shown in
the Application guide are indicative only.
12 Choose and check the spacers to fill the gap
between ring nut and bullhorn d and d
tilt tube and bullhorn considering the thickness of
the stainless washer.
1 2
l
WARNING
Always leave a minimum clearance between
spacers and bullhorn in order to allow the rod tilting
in the tilt tube.
15 Insert the right and left bull horns (12) by
connecting rod and tilt tube rod as shown in the
picture.
1 2
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
MEDIUM
d
l
SMALL
between
2
d
2
1 2
l
page 13
- of 78