‐
Air Controls: Your pellet stove is equipped with a control board that automatically adjusts the
air to fuel ratio for optimum emissions. See your owner's manual for information on operating
the control board, and for other operational information on achieving the best burn, including
these tips:
The control board on this stove allows the user to adjust the heat output and convection blower speed,
and turn the unit on and off.
The lower buttons on the control board (Low Fuel Feed, Low Burn Air, and Air on Temp) are not
meant to be adjusted during normal operation of the unit. These buttons are factory preset and
should not be adjusted by the user.
To energize the unit and initiate a fire, press the "On" button. The LED above the button should
turn green and the control board should display "S U" shortly after pressing the button.
To shut the unit down, press the "Off" button. The LED above the button should turn red and the
board should display "S d" shortly after pressing the button. This initiates the shut down sequence,
and the stove will remain in shut down mode until it has cooled down.
To increase the heat output of the stove, press the "Up" heat range button. The number in the
heat range display window will increase, signifying that the control board is now adjusting the heat
output to your desired level. The blower speed will increase the same amount as the heat range,
because the stove is designed to operate with the blower speed greater than or equal to the heat
range. Pressing the "Down" arrow will decrease the heat range and blower speed.
To increase the blower speed without increasing the heat range, press the Blower Speed "Up"
arrow until the desired blower speed is shown in the display window. Pressing the "Down" arrow
will decrease the blower speed; however, the control board will not allow the blower speed to be
set lower than the heat range
This unit is meant to operate only with the ash pan and main viewing door closed.
Smoke spillage and an inefficient, lazy burn will result from attempting to operate the
In addition, using fuel other than wood pellets can create an unsafe situation and can
also generate excess carbon monoxide. Carbon monoxide is an odorless, colorless gas
which can be deadly. Be sure to burn only wood pellets.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY
.
Caution
stove with either door open.
57
QUESTIONS.