England's Stove Works 25-IP Guide D'installation Et D'utilisation page 55

 The use of outside combustion air is mandatory on this pellet stove.
 The outside air connection pipe protrudes from the lower rear center of the stove; use the included
outside air kit to attach your stove to outside combustion air. Instructions and all the parts needed
to make the outside air connection to your pellet stove are included with the outside air kit.
 If it is not feasible to use the included outside air hookup kit in your stove installation, other
materials may be used, provided the following rules are followed:
 The pipe used for outside air hookup must be metal, with a minimum thickness of .0209 in.
(25 gauge mild steel) or greater and an inside diameter of approximately 2.0 in.
 All pipe joints and connections should be sealed with pipe clamps or other mechanical
means, to insure a leak free outside air connection.
 Long runs of pipe and excessive elbows for outside air should be avoided. Due to frictional
resistance in pipe, any excessive outside air piping can result in poor stove performance.
 A screen or other protection device must be fitted over the outside air termination point to
prevent rain, debris and nuisance animals from entering the piping system.
 Increase the outside air pipe size to 3.0 in. diameter pipe if the outside air connection is
more than 6 ft. in length, more than two (2) elbows are used or if the stove is installed in a
basement.
 The outside air connection system should be inspected at least annually to be certain it is free from
blockage.
‐ Operation and Maintenance – Please refer to the 'Operation' (Operating Instructions) and
Maintenance (including Ash Removal/Disposal) sections of your owner's manual and follow the
guidelines listed therein for safety and for optimal emissions performance.
Additional Information:
Following the instructions in your owner's manual for Start‐Up (lighting a fire) will ensure a proper fire,
as well as helping minimize visible emissions.
More:
‐ Fuel loading and re‐loading: Practical Tips for Building a Fire – See your owner's manual for
information on loading (and re‐loading) your fuel, as well as for fire‐starting procedures.
‐ Fuel Selection: Once your appliance is properly installed, be sure to follow your owner's manual
regarding fuel selection and starting and operating your appliance, including the following
practical tips that will help you obtain the best efficiency from your stove.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY
OUTSIDE AIR HOOK‐UP
55
QUESTIONS.