Thule TO 8000 Instructions page 5

- Ensure that the wiring is connected and cannot come loose.
- Introduce the fuse into the fuse holder. Two long beeps will be heard
immediately.
- Use the remote to program the end switches.
4. CONNECTION INVERTER
You can use an inverter to convert the power supply (12V DC or 24 V DC)
into the suitable power supply for the motor (230V AC).
- Use an inverter which meets this specifications:
input: 10 – 15 V DC (or 20 - 30 V DC)
output: 230V AC / 50Hz
capacity: 300W permanent, 600W max
efficiency (for rectangle wave): min. 90%
- To program your motor : us an inverter with sine wave output or the
230V supply
- Use an inverter with lower voltage security, if not then there is a
possibility that the uncharged inverter will drain your battery.
- Make the connection as on fig. 26.
5. PROGRAMMING OF THE END POSITIONS
See instructions with the tubular motor Nice ERA FIT MHT :
- Quick start guide see p. 27 : Memorizing of the transmitter.
- Quick start guide see p. 27 : Programming of the positions '0' en '1'.
- Complete Nice manual (included) for more information.
6. FINISHING
- Open the awning and fix both end caps with the screws (fig. 3-4).
- Fix the bracket of the remote on the side wall of the vehicle (fig. 16).
You can fix the remote without any wires.
7. POSSIBLE DISTURBANCES
See user instructions 5AP904
5AP905-09 5