Publicité
Les langues disponibles
Les langues disponibles
control, fluid tank and hanging bracket. Accompanying the S-120 foam machine
should be a hanging bracket and fluid tank. If any equipment is missing contact your
ANTARI dealer immediately.
Before beginning initial setup of either the ANTARI Snow Machine or the ANTARI
Foam Machine, make sure that there is no evident damage caused by transportation.
In the event that the unit's housing or cable is damaged, do not plug it in and do not
attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
♦ Remove all packing materials from shipping box. Check that all foam and plastic
padding is removed, especially in the nozzle area.
♦ Place the machine on a flat surface and remove the liquid tank cap.
♦ Fill with ANTARI SL-5 Snow/Foam Liquid, ANTARI SL-5A Premium Snow Liquid
(snow machine only) or other dealer-recommended high-quality water-based
snow or foam fluid. Any other types of fluid can damage the unit. When filled,
place cap back on liquid tank.
♦ For the snow machine, firmly attach the 3 pin connector on the remote control
cable to the proper input on the rear of the machine.
Snow Machine Operation
♦ Plug power cord into a grounded electrical outlet. Turn power switch on rear of
unit to "ON" position.
♦ To emit snow, press the appropriate button on the remote for the desired length of
time.
♦ Two pilot lamps on the remote control indicate power and operation status.
♦ Use the adjustable knob on the remote control to regulate the volume of snow
output.
Foam Machine Operation
♦ Plug power cord into a grounded electrical outlet. Turn the power switch on rear
of unit to the "ON" position.
♦ The machine will begin producing foam as soon as it is turned on. To stop the
foam, turn the power switch to the "OFF" position.
Both the snow machine and the foam machine may be installed floor level or
suspended overhead. When mounting the unit overhead, it is important that the
snow does not shoot directly at anyone's face. Whatever installation method you
choose, do not allow the unit to have more than a 15 degree angle of inclination.
Important: Always monitor tank fluid level during operation. Running a snow
machine or a foam machine without fluid can permanently damage the unit.
If you experience low output, mechanical noise or no output at all, unplug
immediately. Check fluid level, the external fuse, remote connection, and power from
the wall. If all of the above appears to be O.K., plug the unit in again. If snow does
not come out after holding the remote button down for 30 seconds, check the hose
attached to the tank to make sure there is fluid going through the hose. If you are
unable to determine the cause of the problem, do not simply continue pushing the
remote button, as this may damage the unit. Return the machine to your ANTARI
dealer.
3
Publicité
