Table Des Matières; Extension Cords; Device Elements - Kärcher ProHD 400 Ed Mode D'emploi

- Flow rate of water supply must not
fall below 2.5 GPM (gallons per
minute).
- Flow rate can be determined by
running the water for one minute
into an empty 2,5-gallon container.
- The water supply temperature must
not exceed 140°F/60°C.
- Never use the pressure washer to
draw in water contaminated with
solvents, e.g. paint thinners, gaso-
line, oil, etc.
- Always prevent debris from being
drawn into the unit by using a clean
water source. Use additional water
filter.
ProHD 400, ProHD 600 only:

EXTENSION CORDS

Use only 3-wire extension cords that
have 3-prong grounding-type plugs
and 3-pole cord connectors that accept
the plug from the product. Use only ex-
tension cords that are intended for out-
door use. These extension cords are
identified by a marking "Acceptable for
use with out-door appliances: store in-
doors while not in use." Use only ex-
tension cords having an electrical rat-
ing not less than the rating of the prod-
uct. Do not use damaged extension
cords. Examine extension cord before
using and replace if damaged. Do not
abuse extension cord and do not yank
on any cord to disconnect. Keep cord
away from heat and sharp edges. Al-
ways disconnect the extension cord
from the receptacle before disconnect-
ing the product from the extension
cord.
Do not use extension cord with ProHD
400 Ed.
SAVE THESE INSTRUCTIONS!
Please read and comply with
these original instructions
prior to the initial operation of your ap-
pliance and store them for later use or
subsequent owners.
Device elements . . . . . . . . . EN
Safety instructions. . . . . . . . EN
Proper use . . . . . . . . . . . . . EN
Safety Devices . . . . . . . . . . EN
Environmental protection . . EN
Before Startup. . . . . . . . . . . EN
Start up . . . . . . . . . . . . . . . . EN
Operation . . . . . . . . . . . . . . EN
Transport. . . . . . . . . . . . . . . EN
Storage . . . . . . . . . . . . . . . . EN
Care and maintenance . . . . EN
Troubleshooting . . . . . . . . . EN
Accessories and Spare PartsEN
Warranty . . . . . . . . . . . . . . . EN
Technical specifications . . . EN

Device elements

Please unfold the front picture side
1 Nozzle screws
2 Nozzle
3 Spray lance EASY!Lock
4 Trigger gun EASY!Force
5 Safety catch
6 Trigger
7 Safety lever
8 High pressure hose EASY!Lock
9 Push handle, top (extended)
10 Push handle, bottom (slid in)
11 Holder for storage of a nozzle with
screw connection or a surface
cleaner**
12 Nozzle rack for triple nozzle**
13 Recessed grip
14 Nameplate
15 Skid
16 High-pressure connection
EASY!Lock
17 Wheel
- 3
EN
Contents
3
4
4
5
5
5
6
7
8
9
9
9
10
10
11
5