Boiler Operation And Maintenance - Kostrzewa Mini Bio Luxury Notice Technique

10. Boiler operation and maintenance

10. Boiler operation and maintenance
Before maintenance and servicing (boiler cleaning) it is necessary to extinguish
the burner, disconnect the boiler from mains and wait at least an hour for the
boiler to cool down.
10.1 Boiler operation guidelines:
Normal daily operation:
• check correct operation of system components: burner, control system
• check water level on a pressure gauge
• check fuel level and quality and fuel feed system operation
• check hydraulic joints leak tightness
• keep the boiler room clean and tidy
In case of any performance issues, remove the faulty devices or contact an
Authorised Service Centre to arrange a repair or an adjustment.
10.2 Inspection scope and schedule
a) Monthly
• check system water pressure
• check safety valve operation
• check control and safety device operation
• check tightness of all connectors and joints
• check balanced ventilation system
b) Minor inspection (every 6 months)
• check rope seal and gaskets
• check boiler door thermal insulation
• check safety devices (safety valve, safety temperature limiter STB etc.)
• check flue gas (in case of a significant increase in flue gas temperature,
clean the combustion section of the boiler)
c) Major inspection (every 12 months)
• check rope seal and gaskets
• check boiler door and cleanout cover thermal insulation,
• check safety devices (safety valve, safety temperature limiter STB etc.)
• check flue gas
• clean the combustion section of the boiler
• check the thermal insulation of the boiler
• check and adjust burner, adjust control system settings
Leader in pellet boilers
After a long boiler/burner standstill, the residual oxygen in boiler water and the
oxygen from the air mixed with a carbonic acid have highly corrosive properties.
Take any precautions necessary if the boiler downtime is to exceed a week.
Periodically remove soot, sludge and ash from the combustion chamber, flue
tubes and the grate. Clean the boiler as required, at least every 2 weeks.
Remove ash as required.
10.3 Maintenance
10.3.1 Boiler, burner, fuel feed system mechanical maintenance
Regular and correct maintenance of the boiler is essential for the correct
and reliable operation and low fuel consumption of the system. Contact an
Authorised Service Centre at least once a year and after every boiler downtime
to arrange an inspection.
Heating system maintenance procedure:
• deactivate the boiler (system) (stop mode)
• wait for complete stop and allow it to cool
• reduce the boiler temperature to the level allowing for safe maintenance
• open boiler door
• clean the combustion chamber and individual fire tubes
• check the rope seals in the boiler doors (replace if necessary)
• check and clean the burner (remove if necessary) – also, clean the motor
and fan (especially vanes) from the outside
• close the boiler door with the burner installed
• remove the cover from the boiler back door
• clean the combustion products from the rear section of the boiler
• check cover gasket quality (rope seals) and replace as required
• close the rear boiler cleanout
• check smoke duct condition and gas tightness
• check installation and operation of the boiler sensors
• check installation and operation of the fuel feed system, the gear motor,
fuel feed ducts leak tightness and flow capacity.
Mini Bio Luxury 12; 21kW User Manual – EN 10.17
67