Nibe SMS 40 Manuel Installateur page 19

calcf:nn
DM: nn
Bin: nn
Bout: nn
hw: nn
?solar pump: runs/off
BT53: nn
BT54: nn
BT55: nn
?as status: blocked/off/nn kW
5)
/ nn (number of steps)
time factor: nn
- of which hot water: nn
Command Parameter
!op 0/1
!tlhw 0/3/6/12
!reg1 -10-+10
!reg2 -10-+10
!reg3 -10-+10
!reg4 -10-+10
!roomt1 5-30
!roomt2 5-30
!roomt3 5-30
!roomt4 5-30
!vac 1/0
!alarm
!vent 0/1/2/3/4
1) Accessories are required
2) Applies to F370 F470 and F750.
3) Applies to F1145/F1155 and F1245/F1255
4) Applies to F1345
5) Applies to VVM 310, VVM 320, VVM 325 and VVM 500
6) Applies to F750
7) Applies to SMO40
Example
To check the selected operating mode, the following SMS message is sent: ?status
To activate "Temporary lux, hot water" for 12 hours, the following SMS message is sent: !tlhw 12
Both commands are answered with a status message.
Calculated flow line temperature
Degree minutes
Incoming brine temperature
Outgoing brine temperature
Hot water temp.
Status of charge pump for solar accessories
Solar panel temperature
Solar tank temperature, coil
Solar tank temperature, peak
2), 3),
Status of addition
4)
Time factor on addition
Total run time hot water
Answer Description
?status Change operating mode
Auto/add. heat only
?status Temporary lux, hot water. 0/3/6/12 hours.
?status Temperature (offsetting the heat curve in systems without
room sensors)
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 2
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 3
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 4
?status Temperature (setting the room temperature in systems with
room sensors)
?status Temperature (setting the room temperature in systems with
room sensors), climate system 2
?status Temperature (setting the room temperature in systems with
room sensors), climate system 3
?status Temperature (setting the room temperature in systems with
room sensors), climate system 4
?status activating/deactivating holiday settings
Resets alarm
Changed fan speed. 0= normal fan speed
3), 4)
3), 4)
1)
1)
1)
2+1)
2), 3), 4), 5), 7)
6)
1)
1)
1)
1)
1)
1)
2), 3+1), 4+1)
GB
19