Control Panel Removal; End Door Removal / Installation (Cbhd4P Only) - Continental Fireplaces CBHD4N Instructions D'installation Et D'opération

6.4

CONTROL PANEL REMOVAL

Remove screen, see "SCREEN REMOVAL" section.
A.
Lift the second panel using the fi ngers holes and pull forward away from the unit, refer to Figure 1.
B.
Lift the bottom panel up and out of the unit.
C.
FIG. 1
6.5

END DOOR REMOVAL / INSTALLATION (CBHD4P ONLY)

NOTE: Screens must be removed prior to the end door removal, refer to "SCREEN REMOVAL /
INSTALLATION" section.
Remove the main doors from the appliance, refer to the "DOOR REMOVAL/INSTALLATION" section.
A.
Remove the 6 screws securing the end door in place, as shown below. Ensure to keep one hand on
B.
the door, from the inside of the appliance, at all times to prevent it from falling.
Tilt the door from the top downwards and carefully remove it from the appliance.
C.
To install the end door, reverse these steps.
D.
6 screws
37
EN
W415-1283 / 05.02.14