Installing Combustible Board - Continental Fireplaces CBHD4N Instructions D'installation Et D'opération

5.3

INSTALLING COMBUSTIBLE BOARD

A NON-COMBUSTIBLE FINISHING MATERIAL BORDER, SUCH AS BRICK, MARBLE, GRANITE, ETC.
IS REQUIRED. FINISHING WITH JUST NON-COMBUSTIBLE BOARD TO THE SIDES AND TOP OF THE
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
SIDE
WALL
6" (152mm)
MIN. TO A
SIDE WALL
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the
appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and fi nish coat. Paints may discolour.
!
APPLIANCE IS NOT ALLOWED.
NOT USED, CRACKING CAN OCCUR.
CBHD4ST BHD4ST
COMBUSTIBLE
FINISH MATERIAL
38 1/4"
45" (972mm)
(1143mm)
WARNING
CBHD4P
43 1/4"
(1099mm)
BHD4P
COMBUSTIBLE
FINISH MATERIAL
38 1/4"
(972mm)
6" (152mm)
MIN. TO A
SIDE WALL
W415-1283 / 05.02.14
29
EN