Installing The Appliance - Continental Fireplaces CEFL32FH Instructions D'installation Et D'opération

installation
EN
2.4

installing the appliance

Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you install this
appliance on the wall.
Select a location that is not prone to moisture and is located at least
A.
36" (91.4cm) away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
Have two people hold the appliance against the wall to determine the
B.
final location.
Place unit face down on a soft, non abrasive surface. Remove the
C.
bracket from the back of the unit by removing the screws, refer to
Figure 1.
Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST
D.
have the hooks facing upward and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall
studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to the wall and the
bracket is adequately secured.
With the wall mounting bracket
E.
installed, have two people lift the
appliance up and insert the two
hooks on the bracket into the two
slots on the back of the appliance.
Check the appliance for stability
F.
ensuring that the bracket will not
pull free from the wall.
12
W415-1730 / B / 07.28.17
HOOK
CEFL32/42/50FH Bracket Illustrated
CEFL60/72/100FH Bracket Illustrated
GLASS FRONT
SIDE VIEW
FLOOR
SCREWS
BODY
21 5/8"
55cm
HOOK