Fitting The Parking Aid - Dometic MWE7006 Mode D'emploi

MWE7006
6.2 Determining the place of installation for the sensors
See fig. 3 to fig. 6
I
NOTE
The sensors must be correctly aligned for the device to work properly.
If they point to the ground, irregularities and bumps on the surface may
be interpreted as obstacles. If they point too far up, obstacles will not be
detected at all.
Note the following during installation:
• The area around the sensors must be free from other objects.
• The distance from the sensors to the ground should be at least 45 cm and a
maximum of 60 cm (fig. 3).
• Note that the installation angle depends on the installation height.
Select the right sensor holder and the appropriate drill diameter by consulting
the table in fig. 3.
• If a bicycle rack has been fitted, then install the sensors at least 30 cm below it
(fig. 4).
Supplement to fig. 6
➤ Observe the intervals between sensors.
I
NOTE
You can also distribute the sensors as shown in alternative B and C.
7

Fitting the parking aid

See fig. 7 to fig. 0
Supplement to fig. 8
A
NOTICE! Risk of malfunction!
Align the sensor holders so that the fastening lugs are horizontal. Other-
wise, there is no guarantee the parking aid will function correctly.
➤ Push the sensor holders into the holes until they lock into place.
Supplementary to fig. 0
➤ Ensure that the loudspeaker is switched on (Middle or High position).
EN
Fitting the parking aid
7