Fitting The Camera; Tools Required - Dometic WAECO PerfectView CAM33C Notice De Montage Et D'utilisation

_CAM33.book Seite 40 Freitag, 20. Mai 2011 11:40 11

Fitting the camera

7 Fitting the camera
7.1

Tools required

For installation and assembly you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (see fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection, the following tools are re-
quired:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
7.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of the
vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length spec-
ified in the vehicle documents, your vehicle must be inspected by
the appropriate authorities.
Make sure that you are in possession of vehicle documents verify-
ing that your vehicle has passed this inspection.
40
PerfectView CAM33
EN