Installing The Cam1000 / Bsc01 - Dometic CAM 1000 Instructions De Montage Et De Service

Installing the CAM1000 / BSC01

5.2 Display elements of the camera image
Symbol
A or B
6 Installing the CAM1000 / BSC01
See fig. 2 to fig. 0
6.1 Instructions before installation (change acceptance)
• The system BVS71000 - CAM1000/ BSC01 + M75LXAHD with ABE-Nr. KBA91843 requires a
change acceptance by a testing laboratory (for example, DEKRA, TÜV).
• Please observe the manufacturer's installation guidelines.
• The load status has no effect on the function of the system as long as the installation instructions
are observed.
• The electrical connection and commissioning may only be carried out by a specialist in accord-
ance with the information in this assembly and operating manual.
8
Function
Active area
Reference line
Dynamic arrow indi-
cator
GPS
Warning sound
Operation mode
Description
The red field marks the detection range of the
CAM1000. It appears for about 3 seconds after the
ignition is switched on. It indicates the area where
the camera can detect an object. This field can be
used to adjust the camera so that its detection
range covers a certain area.
The reference line appears permanently. It shows
the line between active and inactive area. It should
preferably be positioned parallel to the right vehi-
cle contour.
The dynamic arrow indication starts at the
detected object and moves in the direction of
travel of the vehicle (from rear to front).
Green symbol:
– Optical display of objects
– Warning sound active
Yellow symbol: no GPS signal
– Optical display of objects
– Warning sound inactive
Red symbol: no object detection available
Blue symbol: comfort switching of the buzzer
– Optical display of objects
– Warning sound inactive
Indication of the selected operation mode
CAM 1000 / BSC 01
EN