Switching Off; Switching Off With A Timer; Child Safety Lock - SilverCrest SIKP 2000 C1 Mode D'emploi

9.3 Switching off

• Touch the symbol on/off
off the appliance. An acoustic signal
sounds. The symbol -H- is shown in the
display, as the temperature of the cook-
ing zone is more than 60 °C. The cool-
ing fan carries on cooling the appliance
after it has been switched off.
• The appliance automatically stops the
heat output if the cooking vessel is re-
moved from the cooking zone 2 during
the heating phase. The error message
E 1 is shown in the display and an
acoustic signal sounds. If you do not
place the cooking vessel on the hot
place within approx. 10 seconds, the
appliance switches off. The cooling fan
carries on cooling the appliance after it
has been switched off.
• After 120 minutes without a change in
setting, the appliance switches off auto-
matically. The cooling fan carries on
cooling the appliance after it has been
switched off.
9.4 Switching off with a
timer
1. Touch the symbol 9 during operation.
The control light 13 lights up, min ap-
pears above the display and on the dis-
play the chosen switch-off time appears
in minutes (presetting: 0 minutes, the de-
vice remains on).
2. Change the switch-off time by touching
the symbol 8 in one-minute steps and
by touching the symbol
ute steps. If you have set the chosen time
and touch no further symbols, the timer
starts automatically and the display
switches over to W or °C again. At
short intervals, the remaining time is dis-
played together with min.
NOTE: first the button
5, to switch
once before the switch-off time can be re-
duced in one minute steps by pressing the but-
ton 8.
3. After the preset time has elapsed, the
appliance switches off. An acoustic sig-
nal sounds. The symbol -H- is shown in
the display, as the temperature of the
cooking zone is more than 60 °C. The
cooling fan carries on cooling the appli-
ance after it has been switched off.

9.5 Child safety lock

To prevent unwanted alteration of the set-
tings, the appliance is equipped with a child
safety lock.
NOTE: if the child safety lock is activated
while in operation, the symbols child safety
lock 6 and on/off
and you can switch the device off. You will
only be able to switch the device on, once
the child safety lock has been deactivated.
• Touch the symbol child safety lock
The control light for the child safety
lock 3 lights up and an acoustic signal
sounds. All symbols except the child
safety lock
• Touch the symbol child safety lock
for at least 4 seconds to override the
child safety lock. An acoustic signal
sounds and the control light for the child
safety lock 3 goes out. The symbols are
7 in 10-min-
no longer blocked.
7 must be pressed
5 are not blocked
6.
6 are now blocked.
6
45
GB