Operation; Switching On; Switching Off - SilverCrest SIKP 2000 B1 Mode D'emploi

All manuals and user guides at all-guides.com
__RP100060_B1.book Seite 37 Donnerstag, 13. Februar 2014 12:00 12

8. Operation

DANGER! Risk of fire!
• Heat oil and fat carefully. Overheated
oil and fat is flammable. Do not leave
hot oil or fat unattended.
• DANGER OF EXPLOSION! Never
extinguish burning oil or fat with water.
Smother the flames by closing the cook-
ing vessel with a suitable lid or plate.
Pull out the mains plug.
DANGER! Risk of injury
through burning!
Do not touch the surface of an induc-
tion hot plate, on which a cooking
vessel has been used beforehand.
The temperature of the surface can
still be very high after a cooking ves-
sel has been removed.

8.1 Switching on

1. Place the cooking vessel in the middle
of the cooking zone 2.
2. Insert the mains plug 1 into a wall sock-
et corresponding to the specifications of
the rating plate. An acoustic signal
sounds. At the same time, the display
and control lights are activated shortly
so they can be checked for proper func-
tioning.
The display shows...
... - L -, if the temperature of the cooking
zone is less than 60 °C and
... - H -, if the temperature of the cook-
ing zone is more than 60 °C.
3. Switch on the appliance by touching the
symbol on/off 5.
The control light on/off 4 lights up.
The control light 12 over the symbol
10 flashes.
W (watt) flashes over the display and
on the display you can see the chosen
power setting (presetting: 1000 watt).
NOTE: if you do not initiate any chang-
es within approx. 30 seconds by touch-
ing the symbols 7/ 8, the appli-
ance switches off automatically.
4. Change the heat output by touching the
symbols 7/ 8 in steps of 200 watt
from 200 - 2000 watt. The heating
phase begins immediately after you
have touched one of the two symbols.
The higher the chosen power, the quick-
er the base of the cooking vessel is heat-
ed up.
By touching the symbols
play image changes from W (watt)
to °C. You can now choose the desired
setting also as a temperature specifica-
tion in steps of 20 °C from 60 - 240 °C
(presetting: 120 °C). After the tempera-
ture has been achieved, it is kept at the
specified value.
You can change specified settings at
any time during operation.
You can also touch the symbols uninter-
ruptedly to change the settings.

8.2 Switching off

• Touch the symbol on/off
off the appliance. An acoustic signal
sounds. The symbol -H- is shown in the
display, as the temperature of the cook-
ing zone is more than 60 °C. The cool-
ing fan carries on cooling the appliance
after it has been switched off.
• The appliance automatically stops the
heat output if the cooking vessel is re-
moved from the cooking zone 2 during
the heating phase. The error message
E 1 is shown in the display and an
acoustic signal sounds. If you do not
place the cooking vessel on the hot
place within approx. 10 seconds, the
appliance switches off. The cooling fan
10, the dis-
5, to switch
37
GB