SEVERIN MW 7816 Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
be used to prepare hot sandwiches.
Select the desired cooking time. The power setting cannot be changed. As the meat needs to
be turned after one side is sufficiently browned, and taken out once it is done on both sides,
the whole process should be closely monitored.
Example: programming a cooking time of 30 minutes.
1. Press
2. Turn
3. Press
.
Microwave + light-wave
In this mode, the microwave and light-wave functions are activated alternately at different
time settings. The use of this combination mode shortens the cooking time.
The following two available combinations can be selected by pressing
three times. Once the desired cooking-time has been selected, the cooking process is started
by pressing
.
Combination 1:
The microwave function is active for 30% of the pre-programmed time, while the light-wave
function is active for the remaining 70%.
This programme is useful for fish, potatoes or cooking 'au gratin'.
Combination 2:
The microwave function is active for 55% of the pre-programmed time, while the light-wave
function is active for the remaining 45%.
This programme can be used for poultry, omelettes etc.
Example: you want the Combination 2 programme to run for 25 minutes.
1. Press
2. Turn
3. Press
.
Steam cooking
The steam-cooking function is suitable for cooking fish, vegetables etc.
Example: programming a cooking time of 20 minutes.
1. Press
. The display shows 0:00.
2. Turn
3. Press
.
Note: low water-level alarm
If the water level falls below the min level, the appliance will automatically stop. A beep
signal is heard and the display shows 'DEDE—'.
After the water has been replenished, press
Automatic cooking programmes
These programmes are helpful when cooking or heating up food without having to select any
particular settings, e.g. for power or cooking time. Pre-programmed settings are used, where
only the food-type and the weight or volume need be entered. To achieve even cooking or
browning, it is important to monitor the food closely during the process and, if required, to
turn the food repeatedly. Set the programme in the following way:
1. Turn
. The display shows 0:00.
, until the display shows 30:00.
3 times. The display shows Co-2.
, until the display shows 25:00.
, until the display shows 20:00.
anti-clockwise to access the selection menu. Then turn in the
again and the programme will continue.
26
twice or

Publicité

Table des Matières
loading

Table des Matières