Sera marin PRECISION SPM 800 Mode D'emploi page 8

Maintenance
The rotor and the shaft (1.2) should be replaced in case of
reduced current performance of the sera marin stream
pump SPM 8000 in spite of good cleaning. Pull the current
nozzle off the motor part to do so. The bearing of the ce-
ramic shaft is located at the bottom of the opening in the
middle of the motor block. The rubber bearings should also
be replaced if the ceramic shaft is being replaced. Make
sure the shaft sits in the rubber bearing and the duct of the
current nozzle when installing the shaft.
SAFETEY PRECAUTIONS
• All electrical units must be disconnected from the
mains/power supply before conducting work at the sera
marin stream pump SPM 8000 or the aquarium. Do
not insert pointed objects in the intake openings of the
flow pump while it is in operation. First switch off pump
and then clean it in case free floating plant parts are
trapped in the intake openings.
• Please make sure the frequency and the voltage of the
mains supply equal those on the type plate before using
the unit.
• Do not lift nor carry electric devices by their mains
cord.
• Operate unit only with an inserted fault current protec-
tion switch (RCD or FI with a trip current of 30 mA).
• Use the appliance only for its described purpose.
Technical Data
Voltage
Power uptake
Flow performance approx.
Cable length
Protection class
Water temperature
Spare parts
Rotor with shaft and rubber bearings
Clamping lever suction cup
Warning
1. Children should be supervised to ensure that they do
not play with the appliance.
220 – 240 V 50 Hz
28 W
8,000 l/h
(2,113 US gal./h)
1.4 m (4.6 ft.)
IPX8 up to 1 m (3.3 ft.)
up to 40°C (104°F)
1 m
IPX8
(3.3 ft.)
2. This appliance is not intended for use by persons (in-
cluding children) with reduced physical, sensory or
mental capacities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsi-
ble for their safety.
3. If the supply cord is damaged, the pump is not longer
allowed to be used and should be discarded.
Disposal of the unit:
Waste electrical and electronic equipment (WEEE)
must not get into domestic waste!
If ever the unit cannot be used anymore, the consumer is
legally obliged to hand in waste electrical and electron-
ic equipment (WEEE) separately from domestic waste,
e.g. at a collection point of his community/his district. This
ensures that waste electrical and electronic equipment
(WEEE) is expertly processed and that negative effects to
the environment are avoided.
Therefore electrical and electronic
equipment bears the following symbol:
Manufacturer warranty:
When following the directions for use the sera marin
stream pump SPM 8000 will perform reliably. We are lia-
ble for the freedom from faults of our products for 2 years
beginning with the purchase date.
We are liable for complete flawlessness at delivery. Should
usual wear and tear occur by use as intended by us, this is
not considered a defect. Warranty claims are also exclud-
ed in this case. This particularly refers to the running unit
(rotor with shaft). Legal claims are of course not reduced or
limited by this warranty.
Recommendation:
In every case of a defect, please first consult the special-
ized retailer where you purchased the unit. He will be able
to judge whether it is actually a warranty case. In case of
sending the unit to us we will unnecessarily have to charge
you for occurring costs.
Any liability because of contract breach is limited to intent
or gross negligence. sera will be liable in case of slight
negligence only in case of injuries to life, body and health,
in case of essential contractual obligations and with bind-
ing liability according to the product liability code. In that
case, the extent of liability is limited to the replacement of
contractually typically foreseeable damages.
8