Preselecting The Speed - Flex XFE 7-12 80 Notice D'utilisation

Instruction manual
Switching on and off
Brief operation without engaged switch
rocker:
– Push the switch rocker forwards and hold
in position.
– To switch off the power tool, release the
switch rocker.
Continuous operation with engaged
switch rocker:
NOTE
The electric power tool features a starter
interlock. In other words, the electric power
tool will not start running again if still
switched on after a power failure.
Switching on electric power tool after a power
failure:
– Switch off the electric power tool.
– Switch on the electric power tool again.
– Push the switch rocker forwards and
engage by pressing the front end.
12
– To switch off the power tool, release the
switch rocker by pressing the rear end.

Preselecting the speed

CAUTION
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
To set the operating speed, move the dial to
the required value.
– 1 = lowest speed
– 6 = highest speed
Gently press the switch (4) to accelerate the
power tool up to the preselected speed.
NOTE
If an overload or overheating occurs during
continues operation, the power tool
automatically reduces the speed until the
power tool has cooled down adequately.
XFE 7-12 80