Preselecting The Speed - Flex PE 150 18.0-EC Notice D'instruction D'origine

Continuous operation with engaged
switch rocker
Press and hold down switch (1.).

To lock into position, hold down the locking

button and release the switch (2.).
To switch off, briefly press and release

the switch.

Preselecting the speed

To set the operating speed, move the dial

to the required value.
Gently press the switch to accelerate the

power tool up to the preselected speed.
22
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
In the event of overload or overheating in
non-stop operation, the power tool will
switch off.
To continue working, switch the power tool
off and back on again.
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
If using a polishing paste, use the respective
tool for each paste.
Sponges can be washed in the washing
machine.
For further information on the manufactu-
rer's products go to www.flex-tools.com.
Charger
1 Insertion slot for battery
2 Contacts
3 Ventilation slots
4 Operating state display
5 Power cord with mains plug
The CA 10.8/18.0 charger is designed to
charge FLEX batteries of the following types
– AP 10.8 (2.5 Ah),
– AP 18.0 (2.5 Ah),
– AP 10.8 (5.0 Ah),
– AP 18.0 (5.0 Ah).
PE 150 18.0-EC