Switching On/Off - WOLFF 038588 Mode D'emploi

5.1 Switching on/off

The EXTRO-STRIPPER is operated by using the handle
on top of the central control panel. The machine
is switched on using switch (1). She starts immediately.
By pressing the emergency stop switch (5) in the event of
danger, the entire machine can be shut down.
By turning the switch, the emergency stop is reset.
The machine is equipped with a zero-voltage switch.
It prevents accidental start-up after the power supply is
reconnected
If power is interrupted during operation, the EXTRO-
STRIPPER must be switched on again by pressing key button
(1). (zero-voltage safety switch)
Preparations
Before starting work, cut the floor covering into strips of about 35 cm.
You cannot work faster if you cut wider strips.
To begin, cut one strip crosswise.
Then lift the floor slightly in order to get the blade underneath it.
We recommend to cut the first strip at right angles to the main
working direction. By so doing access to the adjacent strips is
made easier.
Cut the strips smaller if the floor covering is bonded very
securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the
blade only has to be changed if it is twisted or becomes worn.
The driving wheels are subjected to wear. They have to be
changed after approximately 16 mm (0.6 inch) of the surface
has been worn away.
Otherwise the working angle of the striking apparatus will not be
correct especially critical with cork or foam backed carpets.
5.2 Pull Back
The patented Pull Back system was developed to allow for an
easy pulling back of the Extro Stripper. (Pic. 2)
When you have reached a wall or another obstacle during your
work, simpy pull the handle to lift the driving wheels. The machine
comes to a standstill although the wheels continue to rotate.
If you pull the handle more powerfully, you can pull back the
machine to the place where the next lane is to be stripped off.
If the handle is moved forward again, the driving wheels reach
the floor again and the machine moves forward.
When working, make sure the handle is pressed gently to the
front so that the small transportation rollers are lifted.
EXTRO-STRIPPER 2, 230 V #038588, 115 V #039121,RÄSM
(1)
blade`s width Messerbreite
6 5 4 3 2
(Pic. 1)
(3)
1
(Pic. 2)
13