Figure 6-50: Diagnostics - Cisco Systems Linksys WAG54GX2 Guide Utilisateur

Wireless-G ADSL Gateway with SRX200
The Diagnostics Tab
Use this screen to run ping tests and display test results.
Ping Test
Ping Test Parameters
• Ping Target IP. Enter the IP address that you want to ping. This can be either a local (LAN) IP or an Internet
(WAN) IP address.
• Ping Size. Enter the size of the packet.

Figure 6-50: Diagnostics

• Number of Pings. Enter the number of times that you want to ping.
• Ping Interval. Enter the ping interval (how often the target IP address will be pinged) in milliseconds.
• Ping Timeout. Enter the ping timeout (how long before the ping test times out) in milliseconds.
Click the Start Test button to start the Ping Test.
• Ping Result. The results of the ping test will be shown here.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click
the Cancel Changes button to undo your changes. Click Help for more information.
The Backup&Restore Tab
The Backup&Restore tab allows you to back up and restore the Gateway's configuration file.
Backup Configuration
To back up the Gateway's configuration file, click the Backup button. Then follow the on-screen instructions.
Restore Configuration
To restore the Gateway's configuration file, click the Browse button. Then follow the on-screen instructions to
locate the file. After you have selected the file, click the Restore button.
Click Help for more information.
Figure 6-51: Backup&Restore
Chapter 6: Configuring the Wireless-G ADSL Gateway with SRX200 61
The Administration Tab