Dmx Linking - Chauvet Professional Ovation H-105WW Manuel De Référence

Ovation™ H-105WW QRG
AC Plug
Replacing The Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
RDM
(Remote Device
Management)
Mounting
Product
Mounting
Diagram
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Ovation™ H-105WW will work with a DMX controller using a
5-pin DMX serial
www.chauvetprofessional.com.
The Ovation™ H-105WW uses a 5-pin or terminal DMX data connection for its
DMX personalities: 1 Ch, 2 Ch, and 4 Ch. See the User Manual for information
about connecting and configuring the product for DMX operation.
The Ovation™ H-105WW uses the DMX data connection for its Master/Slave
mode. See the User Manual for information about connect and configure the
product for master/slave operation.
Remote Device Management, or RDM, is a standard for allowing DMX-enabled
devices to communicate bi-directionally along existing DMX cabling. The
Ovation™ H-105WW supports RDM protocol that allows feedback to monitor
Temperature and changes to DMX Address and DMX Channel menu map
options. Download the User Manual from
details.
Before mounting this product, read the
included with your mounting hardware. Use at least one mounting point per
product. For our
www.trusst.com/productcategory/accessories-clamps/.
Overhead Mounting
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
connection. A DMX
www.chauvetprofessional.com
Safety Notes
Chauvet line of
Safety Loop
Yoke
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
Primer is available
and any documentation
mounting clamps,
Pendent Mounting
EN
from
for more
go to