Scope Of Supply - Weinmann JOYCE Full Face Mode D'emploi

6 Troubleshooting
Mal-
Cause
functions
Painful
pressure Mask is too
on the tight.
face.
Mask is too
loose.
Mask does
Draught in
not fit.
the eyes.
High therapy
pressure.
Mask not
adjusted
correctly.
Mask
cushion is
damaged.
Hose system
Therapy is not airtight.
pressure is
not Air is
reached. escaping
from pressure
measurement
ports.
Anti-asphyxia
valve:
– incorrectly
fitted
– defective
Solution
Loosen headgear
slightly.
Adjust position of
forehead support.
Tighten headgear
slightly.
Adjust position of
forehead support.
Use mask of different
size. Available from
your distributor.
Use hard mask
cushion (for pressures
up to 40 hPa).
Available from your
distributor.
Adjust headgear.
Adjust position of
forehead support.
Replace mask
cushion.
Check push-fit
connector and fit of
hose sleeves.
Cover pressure
measurement ports
with cap (included in
package).
Anti-asphyxia valve:
fit correctly
replace

7 Scope of supply

Note
All masks are supplied fully assembled
(including headgear HEADstrap).
vented variants
Article
JOYCE Full Face vented‚ size S WM 26410
JOYCE Full Face vented‚ size
M
JOYCE Full Face vented‚ size L
JOYCE Full Face vented‚ size
XL
JOYCE Full Face vented
40 hPa, size S
JOYCE Full Face vented
40 hPa‚ size M
JOYCE Full Face vented
40 hPa‚ size L
JOYCE Full Face vented
40 hPa‚ size XL
JOYCE Full Face GEL vented‚
size S
JOYCE Full Face GEL vented‚
size M
JOYCE Full Face GEL vented,
size L
plus
JOYCE Full Face vented‚
size S
plus
JOYCE Full Face vented‚
size M
plus
JOYCE Full Face vented‚
size L
plus
JOYCE Full Face vented‚
size XL
Article no.
WM 26420
WM 26430
WM 26440
WM 26411
WM 26421
WM 26431
WM 26441
WM 26412
WM 26422
WM 26432
WM 26413
WM 26423
WM 26433
WM 26443
21