Operation; Switching On And Off; Inflation; Area Of Use - Parkside PKZ 180 B2 Traduction Des Instructions D'origine

Operation

NOTE
► The appliance vibrates during operation.
Therefore, always put it down during opera-
tion. There are four feet
the appliance for this purpose.
♦ Remove the required accessories from the ac-
cessory compartment
Switching on and off
Switching the appliance on:
♦ Move the ON/OFF switch
"I" to switch the appliance on. The integrated
control lamp lights up.
Switching the appliance off:
♦ Move the ON/OFF switch
"O" to switch the appliance off. The integrated
control lamp goes out.
CAUTION!
► Caution! This appliance is not designed for
continuous operation. To prevent the motor
from overheating, the appliance may only be
used as follows: within a period of 10 min-
utes the appliance may only be operated at
the rated power input for 15% of the period,
in other words, 1.5 minutes. During the rest of
the time period (cooling phase 8.5 minutes),
the appliance cools down again.
Compressed air hose with quick coupler
Connecting:
♦ Push the compressed air connector
quick coupler of the compressed air hose
the sleeve automatically springs forwards.
Cutting:
♦ Pull back the sleeve on the quick coupler of
the compressed air hose
compressed air connector
CAUTION!
► Caution! When disconnecting the quick
coupler of the compressed air hose
the coupler firmly to prevent injuries caused
by the hose flying off.
│ GB │ IE │ NI
■ 6
on the bottom of
.
into the position
into the position
into the
,
and remove the
.
, hold
Inflation
with adapter
Schrader valve

Area of use:

This application allows for a simple and accurate
inflation. The manometer
tire pressure. Thanks to the integrated release valve
it is possible to reduce the tire pressure if it is
too high.
ATTENTION!
► Please note, the manometer
brated! After inflation, always check the tire
pressure immediately, for example, at a petrol
station.
♦ Ensure that the ON/OFF switch
♦ Press the lever quick coupler
attach it.
♦ Place the lever quick coupler
and then release the lever.
♦ Insert the mains plug
a mains power socket.
♦ Switch the ON/OFF switch
grated control lamp lights up.
♦ Pull the trigger .
♦ Read the air pressure from the manometer
♦ Let the trigger off again.
♦ Switch the ON/OFF switch
as the correct or permissible air pressure has
been reached. The integrated control lamp
goes out.
♦ Press down the lever quick coupler
it off the valve.
♦ Remove the mains plug
power socket.
is used to check the
is not cali-
is set to "O".
downwards to
onto the valve
of the compressor into
to "I". The inte-
.
to "O" as soon
and pull
from the mains
PKZ 180 B2