Binding The Transmitter And Receiver - Spektrum MR4000 Manuel D'utilisation

Failsafe
The throttle failsafe position is set during binding. In the unlikely event that
transmitter signal is lost during use, the receiver will drive the the throttle servo
to its pre-programmed failsafe position. If you power on the receiver before
powering on the transmitter, the receiver enters failsafe mode. Normal control
resumes when you power on the transmitter.
CAUTION: Failsafe activates only in the event that signal is lost from
the transmitter. Failsafe does NOT activate in the event that the receiver
loses battery power.
Powering the receiver with a separate receiver pack
Receiver
Powering the receiver with an ESC
Battery
Receiver

Binding the Transmitter and Receiver

You must bind the transmitter and receiver before the receiver will operate.
During binding, the receiver recognizes the unique ID code in your transmitter.
After you bind the transmitter and receiver, the receiver only responds to your
transmitter.
Electronic
Speed Control
Steering Servo
Throttle Servo
Steering Servo
Battery
To Motor
EN