Wet Conditions Maintenance; Receiver Connection And Installation - Spektrum MR4000 Manuel D'utilisation

EN

Wet Conditions Maintenance

• Gently rinse the mud and dirt off the insert name of component with a
garden hose.
• Remove the battery pack(s) and dry the contacts.
• If you have an air compressor or a can of compressed air available, blow
off the Spektrum MR4000 to help remove any water that may have gotten
into small crevices or corners. Dry any water that may be inside a recessed
connector housing.
• Let the Spektrum MR4000 air dry before you store it. Water may continue to
seep or evaporate out of tight areas for a few hours.
NOTICE: Never use a pressure washer to clean your vehicle.
NOTICE: This Spektrum MR4000 is waterproofed for use in wet conditions.
Make sure the other components in your vehicle are waterproof or water-resis-
tant before driving in wet conditions.
MR4000 Instruction Manual
The Spektrum™ MR4000 4-channel DSMR
compatible with all Spektrum DSMR surface transmitters.
Specifications
Type: DSMR
Dimensions (LxWxH): 1.3 x 0.9 x 0.5 in (33.8 x 22.1 x 12.2mm)
Channels: 4
Band: 2.4GHz

Receiver Connection and Installation

1. Make sure the receiver location in the vehicle is clean and dry.
2. Remove the paper backing from one side of the double-sided foam tape.
3. Apply the double-sided foam tape to the bottom of the receiver.
4. Remove the second paper backing from the receiver.
5. Place the receiver in the vehicle. Gently press down on the receiver to secure
the foam tape.
6. The MR4000 has a 455mm long antenna to allow maximum range on water.
Position the receiver antenna up and away from the receiver. The higher you
position the antenna, the better signal it will receive.
NOTICE: Do not cut or modify the antenna.
®
Weight: 0.6 oz (17 g)
Voltage Range: 3.5–9.6V
Antenna
Sport Surface receiver is
Aux 2 Port
Aux 1 Port
Throttle Port
Steering Port
Bind/Battery Port