Sygonix 43596D Notice D'emploi page 3

Operating instructions
GB
CCD colour camera, 420 TVL,
3.6 mm
Use in accordance with manufacturer's instructions
This camera is meant for surveillance and protection of secluded or critical
areas (e.g. entrance areas, surveillance of underground car parks and the
like).
The product is designed for use indoors and outdoors (IP65).
The camera must be operated with a stabilised direct current of 12 V/DC
only.
Please bear in mind that it is prohibited by law to observe strangers with
this camera without their knowledge and consent. Observe the rules and
regulations of the country where you are using the camera.
Any use other than that described above may damage the product. Moreo-
ver, this may give rise to hazards such as short-circuiting, fi re, electric shock,
etc. No part of the product may be modifi ed or converted!
The safety instructions must be observed at all times!
This product complies with the applicable national and European require-
ments.
All names of companies and products are the trademarks of the respective
owner. All rights reserved.
Scope of Delivery
• Colour camera
• Mounting material (screws/dowels)
• Allen key
• Operating Instructions
Explanation of Symbols
This symbol indicates specifi c risks associated with handling, func-
tion and use.
The "arrow" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume
liability for any consequential damage!
Nor do we assume liability for damage to property or personal
injury caused by improper use or failure to observe the safety
instructions. The warranty will be null and void in such cases.
• The unauthorised conversion and/or modifi cation of the product
is inadmissible because of safety and approval reasons (CE). Never
dismantle the product.
• The camera must to be operated with a stabilised direct current of
12 V/DC only. The inner contact of the round plug should be Plus/+,
the outer contact Minus/-.
• The product is not a toy and must be kept out of the reach of chil-
dren. It should be operated out of the reach of children.
• The use of the surveillance camera system does not replace the
personal supervision of children or people who require special as-
sistance, but only serves as a support to this supervision.
• The camera is suitable for use in indoor and outdoor areas (IP65).
However, it must never be operated in or under water, this will
destroy it.
The home technology brand for the entire house. More information at www.sygonix.com
• The plugs at the connection cable of the camera are not water-
proof or water tight and must therefore be installed in a dry indoor
area.
• The camera should not be exposed to extreme temperatures,
direct sunlight, strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not being pinched or dam-
aged by sharp edges.
• Do not leave packing materials unattended. They may become
dangerous playthings for children.
• Handle the product with care, it can be damaged by impacts,
blows, or accidental drops, even from a low height.
• If the camera is used with other devices (e.g. a monitor), the op-
erating instructions and safety notices for these devices must be
followed as well.
• It can be assumed that safe operation is no longer possible if:
- the device shows visible signs of damage,
- the device no longer works
- the device was stored for a longer period of time in unfavourable
conditions.
- it was exposed to heavy stress during transport
• In commercial institutions, the accident prevention regulations of
the Employer's Liability Insurance Association for Electrical Sys-
tems and Operating Materials are to be observed.
• Ensure that all the electrical connections and connection cables
between the different devices and any extension cables comply
with the regulations and the operating instructions.
• During installation, ensure that the connection cables are not be-
ing pinched or damaged by sharp edges.
• Disconnect the camera from the power supply if the camera is not
to be used for some time (e.g. storage).
• If you have any questions, which are not answered in this man-
ual, please contact our technical service or another specialist.
Installation
For outdoor use we recommend to choose a location that is pro-
tected from rain (e.g. under the eaves) to prevent the formation of
droplets on the camera's front panel that will cause a distorted and
unusable image.
The camera is equipped with a pre-installed wall mount. This is to be tight-
ened to a suitable place using three screws. Use dowels if required by the
surface.
Make sure when screwing into place or when drilling holes that
cables or wires are not damaged.
Invisible placing of the connection cable requires drilling of a suitable hole,
which is large enough to lead the plugs through, below the wall-mount. The
wall mount will then cover the hole and protect the cable from intentional
damage.
Alternatively, the cable may be lead outward via a small opening on the side
of the wall mount. Protect the cable with a suitable cable trench, etc.
The connection plugs are not protected from humidity and need to
be in a dry place; otherwise they will corrode.