Skandika Bragi Mode D'emploi page 22

22
SET UP INSTRUCTIONS
STEP 4: HANDLEBARS
Remove the plug (65) from the upper hole of the handlebar post (7), place the two cables of the handlebar grip
(8) into the plug and thus guide the cables through the hole of the handlebar post (7) as shown. The plug (65)
must be reinserted into the hole. Now attach the handlebar grip (8) to the handlebar post (7) using the cover (72),
the sleeve (63) and the T-bolt (73). Do not nally tighten yet. Before you nally tighten the assembly, adjust the
handlebar grip (8), which is initially only loosely xed, to the desired position. Make sure that the cables are not
damaged.
Loosen the screws (19) from the back of the computer (9), connect all cables to the computer and then x the
computer (9) on the bracket on top of the handlebar post with the screws (19) as shown.