Loaded Codes; Level 1 Setup (For Manufacturer And Dealers); Performing Level 1 Setup - Betamotor ALP4T 125 cc 2006 Mode D'emploi

1

10.4 Loaded codes

Each speedometer layout contains a table showing the codes and the related descrip-
tions. The contents of each code can be checked at any moment.
20.0 LEVEL 1 SETUP
It allows choices to be made and values to be entered in all fields:
• Code selection
or, alternatively:
• setting of
• wheel circumference or diameter,
• number of pulses per wheel revolution,
• number of pulses per engine revolution,
• maximum rpm.
• entering or altering the
• hours to oil change,
• km or hours to service,
• speed unit, Km/h or Mph, the default being Km/h.

20.1 Performing level 1 setup

• With the instrument switched off, press and hold down the SCROLL button.
• Start the vehicle while the battery is connected.
• After approximately 7 seconds WS will be displayed in the bottom right corner as
shown in Figure 1.
• Hold down the SCROLL button and operate the high beam button, turning the
beam on and off 5 times.
• When SCROLL is released, the display will appear cu as shown in Figure 2 if the
instrument has never been set up before. Otherwise the code adopted during the
previous setup will be displayed as shown in Figure 3.
GB
Figure 1
96