Setting The Number Of Hours Or Kilometres To The Next Service; Exiting Setup - Betamotor ALP4T 125 cc 2006 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1
20.4.6 Setting the number of
hours or kilometres to the next
service
Press and hold down the SCROLL but-
ton until the bars - - - - are displayed.
When the button is released, the display
will appear as shown in Figure 14.
Pressing SCROLL for a short time tog-
gles between Km/h and CLK.
To confirm the current selection, press and
hold down the SCROLL button until WS
is briefly displayed in the bottom right
corner. After releasing the button, enter
and save the value by following the pro-
cedure described for Figure 7. At the end
of the operation, the display will appear
as shown in Figure 13. Pressing SCROLL
for a short time brings up the End cap-
tion.

20.5 Exiting setup

Pressing SCROLL for a short time while
End is displayed returns to the menu,
bringing back the display to the status
shown in Figure 5.
Pressing SCROLL until the bars - - - -
are displayed and then releasing it causes
the instrument to go into test mode (Fig-
ure 15).
The same result is obtained by turning
the instrument off and then on again.
The test is a general check of all the seg-
ments and icons on the LCD display and
of all the warning lights.
The test lasts 3 seconds.
At the end of the test the default page
will be displayed.
GB
Figure 13
Figure 14
Figure 15 - TEST
102

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Alp4t 200 cc 2006

Table des Matières