Testing Your Blood Glucose; Preparing The Lancing Device For Blood Testing; Preparing The Puncture Site - Fora COMFORT check G40 Manuel De L'utilisateur

Testing Your Blood Glucose

Test Strip Appearance
Absorbent Hole
Apply a drop of blood
here. The blood will be
automatically absorbed.
Test Strip Handle
Hold this part to insert
the test strip into the slot.
Front
ATTENTION:
The front side of test strip should face up when inserting test strip.
Test results might be wrong if the contact bar is not fully inserted into
the test slot.
Confirmation Window
This is where you confirm
if enough blood has been
applied to the absorbent hole
in the strip.
Contact Bars
Insert this end of the test strip
into the meter. Push it in firmly
until it will go no further.
Note:
The FORA COMFORT check G40 meter should only be used with
FORA COMFORT check G40 Test Strips.
To reduce the chance of infection:
• Never share a lancet or the lancing device.
• Always use a new, sterile lancet. Lancets are for single use only.
• Avoid getting hand lotion, oils, dirt, or debris in or on the lancets
and the lancing device.
Preparing the Lancing Device for Blood
Testing
Please follow the instructions in the lancing device insert for
collecting a blood sample.

Preparing the Puncture Site

Stimulating blood perfusion by rubbing the puncture site before
blood extraction has a significant influence on the glucose value
obtained. Blood from a site that has not been rubbed exhibits
a measurably different glucose concentration than blood from
the finger. When the puncture site was rubbed prior to blood
extraction, the difference was significantly reduced.
Please follow the suggestions below before obtaining a drop
of blood:
• Wash and dry your hands before starting.
• Select the puncture site either at fingertips or another body
EN-7