Commissioning; Installation And Function Checks; Quick Setup; Set-Up With Profibus - Endress+Hauser iTEMP TMT184 PROFIBUS-PA Manuel De Mise En Service

TMT184
Installation and
function checks
!

Commissioning

!
Endress+Hauser
6 Commissioning
6.1

Installation and function checks

Make sure that all checks have been made before the unit is operational:
• See »Connection control« on page 53.
Note!
• All function technical data of the PROFIBUS interface to the IEC 61158-2 must be adhered to
(FISCO_model).
• Monitor the Bus voltage using a standard multi-meter. This should lie from 9 to 32 volts with a
current of 10 ± 1 mA at the unit.
6.2 Commissioning
The head transmitter is operational once the power supply is active.
6.2.1

Quick Setup

A Quick Setup of the PROFIBUS-PA
gramme Commuwin II and the E+H unit matrix ( → chap. 5.2.7). The function description of the
parameters can be found in the matrix description in chapter »Unit matrix PROFIBUS-PA
rature head transmitter« on page 62.
6.2.2

Set-up with PROFIBUS

Set-up unit address
• Addressing:
The address of a PROFIBUS-PA
0 to 125. In a PROFIBUS-PA
set up incorrectly the measurement unit will not be recognised by the master. The address 126 is
to be used for initial commissioning and service reasons.
• Delivery condition:
All units are delivered with the address 126 and software addressing.
• Software addressing PROFIBUS-PA
the software addressing is done via this server.
Note!
Connection between the operating programme Commuwin II must be disconnected using the
menu Connection disconnect before changing the software addressing!
→
®
head transmitters is possible using the E+H operating pro-
®
unit must always be set up. Valid unit addresses lie in the range
®
network an address can only be allocated once. If the address is
®
using the DPV1 server of Commuwin II. The changeover of
6 Commissioning
®
tempe-
73